
WARNING
This product, when used for welding or cutting, produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
The following terms are used interchangeably throughout this manual:
TIG = GTAW
Stick = SMAW
TABLE OF CONTENTS
SECTION 1 – SAFETY PRECAUTIONS - READ BEFORE USING | 1 | |
Symbol Usage | 1 | |
Arc Welding Hazards | 1 | |
3 | ||
Principal Safety Standards | 3 | |
EMF Information | 4 |
SECTION 1 – CONSIGNES DE SECURITE – LIRE AVANT UTILISATION | 5 | |
Signification des symboles | 5 | |
Dangers relatifs au soudage à l’arc | 5 | |
| ||
| et la maintenance | 7 |
Principales normes de sécurité | 8 | |
Information sur les champs électromagnétiques | 8 |
SECTION 2 – DEFINITIONS | 9 | |
Warning Label Definitions | 9 | |
Rating Label For CE Products | 10 | |
Symbols And Definitions | 10 |
SECTION 3 – INTRODUCTION | 11 | |
Specifications | 11 | |
SECTION 4 – INSTALLATION | 11 | |
Site Selection | 11 | |
Rear Panel Connections And Rotating Drive Assembly | 12 | |
13 | ||
Gun Recommendation Table | 13 | |
Wire Type, Size, And Feed Speed Capability Table | 13 | |
Installing And Threading Welding Wire | 14 | |
Setting Internal DIP Switches | 15 | |
SECTION 5 – OPERATION | 16 | |
Operational Terms | 16 | |
Power Switch | 16 | |
Front Panel Controls | 17 | |
Program Push Button | 18 | |
Upper Display | 18 | |
Lower Display | 19 | |
Setup Push Button | 19 | |
Adjust Control | 20 | |
Sequence Push Button | 20 | |
22 | ||
Jog/Purge | 24 | |
SECTION 6 – SETTING SEQUENCE PARAMETERS | 25 | |
Sequence Parameters In A Program | 25 | |
SECTION 7 – SETTING DUAL SCHEDULE PARAMETERS | 26 | |
26 | ||
SECTION 8 – MAINTENANCE | 26 | |
Routine Maintenance | 26 | |
Diagnostics | 27 | |
SECTION 9 – ELECTRICAL DIAGRAM | 28 | |
SECTION 10 – PARTS LIST | 30 | |
Warranty |
|