Bosch Power Tools 11236VS manual Slip Clutch, Auxiliary Handle, Depth Gauge, Tool Tips

BM 1619929532 02-08 2/15/08 4:00 PM Page 8

QUICK CHANGE SDS-plus®BIT HOLDER This tool features a removable bit holder, which allows a rapid exchange of the SDS- plus bit holder should it become damaged.

To remove the SDS-plus	LOCKING SLEEVE
bit holder assembly,
rotate the locking sleeve
in the rotational direction
of the bit (clockwise) until
it stops. When the
locking sleeve stops, pull
the whole SDS-plus bit
holder assembly outward

until it pulls free from the tool’s spindle mount.

To re-install SDS-plus bit holder, align the steel balls inside the accessory with the grooves in the front of the tool’s spindle mount. Next rotate the bit holder’s locking sleeve (clockwise) until it stops. Then press slightly inward towards back of tool until it locks in place.

After installing the bit holder always pull outward on the bit holder to be certain it is locked onto to spindle mount.

SLIP CLUTCH

The tool has a internal pre-set slip clutch. The output spindle will stop rotating if the accessory binds and overloads the tool.

AUXILIARY HANDLE

The tool can be supported with the auxiliary handle , which can be swiveled 360˚. To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip.

DEPTH GAUGE

Your drilling depth can be pre-set and/or repeated by using the depth gauge.

Setting depth: After the auxiliary handle is installed, slide the depth gauge to desired depth and securely tighten wing knob.

"TOOL TIPS"

For the best penetration rates in concrete, run the tool with a steady pressure, but do

not use excessive force as this will decrease the efficiency of the tool.

All grease packed hammers require a short period of time to warm up. Depending on the room temperature, this time may vary from approximately 15 seconds (90˚F) to 2 minutes (32˚F). A new hammer requires a break-in period before full performance is realized. This period may require up to 5 hours of operation.

A rotary hammer is likely to be the most expensive portable tool at the construction job. The long wear and efficient operation of the BOSCH hammers will more than justify the cost for tools of this type. As earlier pointed out, sharp accessories as well as clean air vents are necessary for efficient operation. Establish and follow a set maintenance program.

-8-