Bosch Power Tools 11250VSRD manual DRILL/HAMMER Drill Selection Dial

BM 1619929567 10-03 3/2/04 9:40 AM Page 8

DRILL/HAMMER DRILL SELECTION DIAL

The selector dial allows the tool to be set for various drilling/hammer drilling applications. Depress release button and turn selector dial right or left depending on the below applications.

Drill only action: For drilling in woods, metals, plastics or other non concrete materials.

!CAUTION Do not operate the selection dial until the tool

come to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.

Do not use demolition or chipping bits such as bull points, chisels, spades, gouges, etc.

Drill with hammer action: For drilling in concrete, asphalt, tile or other similar hard materials.

INSTALLING ACCESSORIES

!WARNING Disconnect the plug from the power source before making

any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.

The 11250VSR Rotary Hammer utilizes “SDS” drill bits. The “SDS” system efficiently transfers drilling torque and maximizes the energy delivered per hammer blow.

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.

Insert accessory into the tool holder through the dust shield, while twisting and pushing

inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the tool holder (Fig. 5).

FIG. 5

DUST SHIELD

REMOVING ACCESSORIES

! WARNING	When removing the bit from	FIG. 6
	the tool avoid contact with

skin and use proper protective gloves when grasping the bit or accessory. Accessories may be hot after prolonged use.

To remove an accessory, pull the locking sleeve backwards (towards the rear of tool), while pulling the accessory outward. All accessories should be wiped clean after removing (Fig. 6).

LOCKING

SLEEVE

-8-