1.Clearly mark the work area.
2.Plug in the Breaker Hammer.
3.Place the Chisel on the block you will be breaking.
NOTE: Carbon Brushes (51) will wear during use. The Breaker Hammer will cease functioning if the Brushes are worn. This does NOT mean Breaker Hammer is malfunctioning or broken, only that the worn Brushes will need to be replaced with the included Brushes by a qualified technician.
4.Grasp the handles firmly with both hands and depress the Trigger (86).
5.As you break the block into big chunks, release the Trigger (86) and move to other large pieces until all of the larger pieces are broken. Do not try to break up smaller pieces with this tool as it is too powerful and aggressive to control on small pieces.
6.When you are finished, release the
Trigger (86) and unplug the cord.
7.Clean, then store indoors out of children’s reach.
Important - Replacing Carbon
Brushes
The Breaker Hammer will cease operation once the carbon brushes are worn.
Check Carbon Brushes (51) after every hundred (100) hours of regular use. If brush change is necessary, it must be done by a qualified service technician.
Screws (1)
Cover (2)
Figure 4
1.Set the Breaker Hammer down on a work bench with the spline axles closer to the top. Use a 5mm Hex Wrench (not included) to loosen the four Screws (1) fastening Cover in place. See Figure 4.
Cover (2)
Figure 5
2.Slide Cover off top of Breaker Hammer. See Figure 5.
REV 10e |
|
|
SKU 96035 | For technical questions, please call | Page 13 |