2.Power Switch (66): The Demolition Hammer is switched “ON” by the slide switch located in the rear Handle (62). To turn the tool “ON”, slide the switch to the right. To turn the tool “OFF”, slide the switch to the left. (See Figure E.)
3.Variable Speed Control (72): The Demolition Hammer is equipped with a Variable Speed Control Dial. The impact rate (BPM) and rotating speed (RPM) can be varied according to the type of work being performed by setting the Variable Speed Control Dial to the selected setting:
4.Auxiliary Handle (104) and Knob (105): The Demolition Hammer must be supported with the Auxiliary Handle, which can be swiveled 360 degrees. To reposition and/or swivel the Auxiliary Handle, loosen the Knob. Move the Auxiliary Handle to the desired position along the barrel of the tool and firmly retighten the Knob. (See Figure E.)
5.Front Cap (1) and Slider (4): To install a Chisel (106, 107), clean the insert shank end of the chisel to remove any debris. Then, lightly grease the shank with a light oil or grease. Insert the Chisel into the Slider through the Front Cap, while twisting and pushing inward until the Chisel locks into place. (Pull outward on the Chisel to make sure it is locked into the Slider. (See Figure F.)
SLIDER (4)
OIL OR GREASE
(NOT INCLUDED)
CHISEL
FRONT CAP
(106, 107)
CHISEL
(1)
FIGURE F
(106, 107)
FRONT CAP (1)
SLIDER (4)
OPERATING INSTRUCTIONS
WARNING! Always wear
SKU 93853 | For technical questions, please call | PAGE 12 |