Connector
Connector
Step 5: Holding the front housing secure, slowly lift the rear housing off.
Step 6: Pull reflector away from rear housing being careful not to pull wire connections inside. Do not touch the inside of reflector.
NOTE: The glass lens is not attached to front housing. Use care when disassembling to avoid breaking lens.
Step 7: Pinch the ends of the wire retainer together and lift up as illustrated.
Step 8: Pull bulb straight out from the reflector mounting plate.
Step 9: Disconnect bulb wire from connector by holding the connector firmly with fingers then pulling bulb wire straight out.
Step 10: To install new bulb, grasp the bulb from the metal end (DO NOT TOUCH THE GLASS PART) and insert into the reflector mounting plate. Align the slots in the bulb base with those in the reflector mounting plate.
Step 11: Replace wire retainer by pinching ends together while pressing down. Push ends apart so they catch on the reflector mounting plate.
Step 12: Reconnect the bulb wire to the connector as illustrated.
Step 13: To reassemble, place the front housing face (lens) down on a flat surface. Set the reflector into the rear housing. Insert the rear housing into the font housing of the spotlight.
Step 14: Replace the two screws that were removed in Step 3. Do not over tighten screws.
Replacement bulbs may be purchased from The Brinkmann Corporation Customer Service Department by calling
5