Chauvet Vue II Setting up a DMX Serial Data Link, Cable Connectors, PIN to 5-PIN Conversion Chart

Page 8

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female XLR connector on the other end.

DMX connector configuration

 

 

COMMON

 

1

DMX +

INPUT

3

 

 

2

DMX -

 

 

1

Resistance 120

3

ohm 1/4w between

pin 2

(DMX -) and

2

pin 3

(DMX +) of

 

the last fixture.

1

OUTPUT

3

2

Termination reduces signal errors and

 

to avoid signal transmission problems

and interference, it is always advisable to connect a DMX signal terminator.

CAUTION

Do not allow contact between the common and the fixture’s chassis ground. Grounding the common

 

can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to

 

verify correct polarity and to make sure the pins are not grounded or shorted to the shield or each other.

3-PIN TO 5-PIN CONVERSION CHART

Note! If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter. CHAUVET Model No: DMX5M, or DMX5F.

The chart below details a proper cable conversion:

3PIN TO 5 PIN CONVERSION CHART

Conductor

3 Pin Female (output)

5 Pin Male (Input)

Ground/Shield

Pin 1

Pin 1

Data ( - ) signal

Pin 2

Pin 2

Data ( + ) signal

Pin 3

Pin 3

Do not use

 

Do not use

Do not use

 

Do not use

Setting up a DMX Serial Data Link

1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.

2.Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector.

3.Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

CHAUVET Certified DMX Data Cables

Order Code

Description

DMX1.5

DMX Cable 1.5m/4.9ft

DMX4.5

DMX Cable 4.5m/14.8ft

DMX10

DMX Cable 10m/32.8ft

Universal DMX Controller

This drawing provides a general illustration of the DMX Input/Output panel of a lighting fixture.

Continue the link

Vue™ II User Manual

8

2007-05-10/13:15

Image 8
Contents Snapshot Table of Contents What is included AC PowerBefore YOU Begin Unpacking InstructionsSafety Instructions DMX Channel Summary FeaturesIntroduction Product Overview Setup Fuse ReplacementFixture Linking Data CablingPIN to 5-PIN Conversion Chart Setting up a DMX Serial Data LinkCable Connectors Stand-Alone/Master/Slave Fixture Linking MountingOrientation RiggingMaster/Slave Mode Master Sound, Master Auto Operating InstructionsDMX Mode DMX Channel ValuesSetting the Starting Address OFFDMX Address Quick Reference Chart DMX Quick Reference ChartGeneral Troubleshooting Applies toGeneral Maintenance AppendixTechnical Support DMX PrimerClaims Returns ProcedureTechnical Specifications