ASSEMBLY
Your Spotlight comes completely assembled. When unpacking your Spotlight, check to make sure that all the parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
OPERATION
To assist you with operating your Spotlight, please refer to Figure 1 on page 4.
CHARGING
Your Spotlight Battery (8) is rechargeable. It can be charged by either using the Power Adapter (26) or the Car Adapter (25).
To recharge your Battery (8) using the AC/DC Adapter (26).
Step 1) Insert the cord end of the AC/DC Adapter (26) into the outlet on the back of the Spotlight. Plug the Power adapter (26) into an electrical outlet.
Step 2) The red light on the side of the Left Trim (4) piece will light, indicating that the unit is properly plugged in. For the initial charge of the Spotlight, leave the Power Adapter (26) plugged in for between 14 and 16 hours until the Spotlight is fully charged. The red light will shut off automatically when the battery is fully charged. Subsequent charges of the Battery will take approximately 12 to 14 hours.
IMPORTANT: Always unplug the Power Adapter (26) from the Spotlight after the Spotlight is charged.
The Spotlight will not function properly if the Power Adapter is plugged into the Spotlight.
Note: After each use of the Spotlight, always fully recharge the battery.
Note: This unit is equipped with an automatic shutoff. If the Battery’s Power is running low, the unit will automatically stop operating to protect the battery. Charge the battery immediately.
To recharge your Battery (8) using the Car Adapter (25)
Step 1) Insert the cord end of the Car Adapter (25) into the outlet on the back of the Spotlight. Plug the plug end of the Car Adapter (25) into your car’s lighter. For the initial charge, the Spotlight must be charged for between 8 and 11 hours. The red light will shut off automatically when the battery is fully charged. Subsequent charges of the Battery will take approximately 4 to 7 hours.
Note: When charging the Spotlight, only place the Spotlight on a
IMPORTANT: Always unplug the Car Adapter (25) from the Spotlight after the Spotlight is charged. The Spotlight will not function properly if the Car Adapter is plugged into the Spotlight.
Tripod Adapter
Your Spotlight can be mounted onto a tripod or workstand (neither is included). At the bottom of the Trigger Grip Handle there is a Tripod Adapter (21). Thread the tripod or workstand into this Tripod Adapter.
On/Off Switch
Press the switch the first time and either spotlight or flood light will go on. Press the switch again to turn off the light. Press the switch again and you will get the opposite light that went on after pressing the switch the first time (either the spotlight or flood light). Press switch again and light will go off. Push the Trigger Lock (19) on the side of the handle to lock the Trigger ON, or lock the Trigger OFF.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE, DO NOT OPERATE THE TOOL.
REV 01/07
SKU 93366 | Page 3 |