Makita 9558NB, 9556NB, 9557NB instruction manual 100 mm

Operation with abrasive cut-off / diamond wheel (optional accessory)

The direction for mounting the lock nut and the inner flange varies by wheel thickness.

Refer to the table below.

1

2

3

4

010855

1.Lock nut

2.Abrasive cut-off wheel/ diamond wheel

3.Inner flange

4.Wheel guard for abrasive cut-off wheel/ diamond wheel

100 mm (4")

	Abrasive cut-off wheel			Diamond wheel
Thickness: Less than 4 mm (5/32")		Thickness: 4 mm (5/32") or more	Thickness: Less than 4 mm (5/32")		Thickness: 4 mm (5/32") or more

1

2

1

4

16 mm (5/8")			16 mm (5/8")
		3		20 mm (13/16")		3	20 mm (13/16")
1. Lock nut	2. Abrasive cut-off wheel			3. Inner flange	4. Diamond wheel

115 mm (4 - 1/2") / 125 mm (5")

Abrasive cut-off wheel				Diamond wheel
Thickness: Less than 4 mm (5/32")		Thickness: 4 mm (5/32") or more	Thickness: Less than 4 mm (5/32")		Thickness: 4 mm (5/32") or more
		1			1
		2			4
22.23 mm (7/8")		22.23 mm (7/8")	22.23 mm (7/8")		22.23 mm (7/8")
		3			3
1. Lock nut	2. Abrasive cut-off wheel		3. Inner flange	4. Diamond wheel

010848

WARNING:

•When using an abrasive cut-off / diamond wheel, be sure to use only the special wheel guard designed for use with cut-off wheels. (In some European countries, when using a diamond wheel, the ordinary guard can be used. Follow the

regulations in your country.)

•NEVER use cut-off wheel for side grinding.

•Do not "jam" the wheel or apply excessive pressure. Do not attempt to make an excessive depth of cut. Overstressing the wheel increases the loading and susceptibility to twisting or binding of the wheel in the cut and the possibility of kickback, wheel breakage and overheating of the motor may occur.

10