Operation, Super flange accessory | Makita 9556NB, 9558NB, 9557NB

Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard to such an angle that it can protect the operator according to work. Be sure to tighten the screw securely.

To remove wheel guard, follow the installation procedure in reverse.

Installing or removing depressed center grinding wheel/Multi-disc

OPERATION

WARNING:

•	It should never be necessary to force the tool. The
	weight of the tool applies adequate pressure.
	Forcing and excessive pressure could cause
	dangerous wheel breakage.
•	ALWAYS replace wheel if tool is dropped while
	grinding.
	NEVER bang or hit grinding disc or wheel onto

001070

WARNING:

1.Lock nut

2.Depressed center grinding wheel/Multi-disc

3.Inner flange

•
	work.
•	Avoid bouncing and snagging the wheel, especially
	when working corners, sharp edges etc. This can
	cause loss of control and kickback.
•	NEVER use tool with wood cutting blades and other
	sawblades. Such blades when used on a grinder
	frequently kick and cause loss of control leading to
	personal injury.

CAUTION:

•Always use supplied guard when depressed center grinding wheel/Multi-disc is on tool. Wheel can shatter during use and guard helps to reduce chances of personal injury.

Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock nut onto the spindle.

Super flange (accessory)

Models 9558NB are standard-equipped with a super flange. Only 1/3 of efforts needed to undo lock nut, compared with conventional type.

To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise.

	1	1. Lock nut wrench
	1	2. Shaft lock
		2. Shaft lock

005917

To remove the wheel, follow the installation procedure in reverse.

WARNING:

Only actuate the shaft lock when the spindle is not moving.

•	After operation, always switch off the tool and wait
	until the wheel has come to a complete stop before
	putting the tool down.

Grinding and sanding operation

ALWAYS hold the tool firmly with one hand on housing and the other on the side handle. Turn the tool on and then apply the wheel or disc to the workpiece.

In general, keep the edge of the wheel or disc at an angle of about 15 degrees to the workpiece surface.

During the break-in period with a new wheel, do not work the grinder in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B direction.

	15
A	B
005831