Switch action
Slide the slide switch forward to start, and the switch will lock in the "ON" position. To stop, lgihtly depress the rear of the switch, and it will return to the "OFF" position.
CAUTION :
Before plugging in the tool, always check to see that the switch actuates properly and returns to the "OFF" position when depressed.
Operation
Hold the tool firmly. Turn the tool on and then apply the wheel or disc to the work- piece.
In general, keep the edge of the wheel or disc a t an angle of about 15' to the work- piece surface.
During the
WARNING:
Slide switch
7
0 It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
.Continued use of a
6