Harbor Freight Tools 93088 operating instructions Use

Page 8

Use

1.Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet regulator over 90 PSI.

2.Connect the Die Grinder to the air compressor’s hose. If leaking is detected, disconnect the air hose and repair before use.

3.

Place the material you will be grinding into a vise or other-

WARNING!

Wear protective gloves,

 

wise clamp the object so that it will not move around when

 

goggles, and a dust mask

 

you use the Die Grinder. Make sure you still have unob-

 

when operating this tool.

 

structed access to the area you will be grinding.

 

 

 

 

4.Grip the Die Grinder firmly with your hand. To begin grinding, press the LEVER (4).

Press the LEVER before you touch the Grinding Attachment to the surface.

5.Your Die Grinder’s speed is variable. To vary the speed of the Die Grinder, vary the pressure on the LEVER.

6.Allow the Grinding Attachment to do the work. Do not use excessive force to press the Die Grinder and Grinding Attachment into the surface you are grinding. If you put pres- sure on the Die Grinder and it stalls, immediately release the LEVER and pull the Die Grinder off of the surface.

SKU 93088

For technical questions, please call 1-800-444-3353.

Page 8

Image 8
Contents Angle die grinder Specifications Read ALL Instructions Before Using this ToolSKU For technical questions, please call Grinding Attachment Installation UnpackingAssembly Grinding AttachmentWrench Placement Air Connection OperationUse Maintenance Lubrication PointsPlease Read the Following Carefully Assembly Diagram Limited 90 DAY Warranty