5.Check to be sure all attachments are secure before turning on the tool. Adjust the Wheel Guard so that it provides a shield between you (the user) and the material you are working on. The Wheel Guard must be in place at all times when using the Angle Grinder.
6.Grip the Handle [35] with your left hand and the Housing [25] with your right hand. Depress the Lever [31] with your right hand to turn the tool on. Allow the motor to reach its full speed before grinding. Make sure the Wheel is rotating evenly and all parts appear to be working properly. Always maintain a firm grip with both hands when operating this tool.
7.To begin cutting or grinding, approach the material at an angle between 15 and 30 degrees to the Wheel. Maintain that angle until you are finished cutting/grinding. Do not force the Wheel or apply too much pressure. If the Wheel slows down as you work with your material, you are applying too much pressure.
8.Once you have turned the Grinder off, continue to hold onto the tool with both hands until the motor stops completely before you set it down.
Maintenance and Troubleshooting
Caution: Always disconnect the Air Grinder from its compressed air supply source before performing any cleaning, servicing, or maintenance.
Before use, add a few drops of light tool oil into the air inlet (26). See assembly diagram on page 8. If the tool stops turning, the Rotor Blades (21) may be gummed up or damaged. You can remove and clean them or replace them if needed. See page 8. Call
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 95504 | Page 7 |