4.An undamaged wheel will emit a clear metallic ring or “ping” sound in each of these spots. A damaged wheel will respond with a dull thud that has no clear tone.
5.If you determine from the ring test that the wheel is damaged, DO NOT use it!
Finally, check that the grinding surface is square. Lower the universal support to
1
| Universal |
| Support |
| Grinding |
Check | Surface |
Parallel |
|
Figure 5. Parallel check.
Test Run
Once your Model T10097 is positioned, test run the machine to make sure it runs properly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine imme- diately, then review the Troubleshooting on Page 20.
If you still cannot remedy a problem, con- tact our Tech Support at (570)
To test run the machine:
1.Make sure you have read the safety instructions at the beginning of the manual and that the grinder is setup properly.
2.Make sure all tools and objects used during set up are cleared away from the grinder.
3.Make sure the switch is in the OFF position.
4.Connect the grinder to the power source.
5.Turn the grinder ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine OFF.
6.Listen to and watch for abnormal nois- es or actions. Under normal conditions, the grinder will make a humming noise, with only minor vibration.
—Investigate strange or unusual nois- es and correct them before oper- ating the machine further. Always disconnect the machine from power before investigating or correcting potential problems.
7.Turn the grinder OFF.
8.Pull out the switch disabling key and attempt to turn the machine ON.
—If the grinder does not start, the switch disabling feature is working.
—If the grinder starts, turn it OFF. The switch disabling feature is not working. This safety feature must work properly before proceeding. Call Tech Support for help.
Model T10097 Wet Grinder |