CIRCUIT REQUIREMENTS
110V Operation
Amperage Draw
The Model T10097 motor draws the follow- ing amps under maximum load:
Motor Draw | 1.2 Amps |
Minimum Circuit Requirement
We recommend connecting your machine to a dedicated and grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing circuit with one of higher amperage with- out consulting a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, consult a qualified electrician.
110V Circuit.................................. 15 Amps
Plug/Receptacle Type
Included Plug Type...................NEMA 5-15
<gdjcY^c\Egdc\^h Adc\Zhid[i]ZI]gZZ Egdc\h
8jggZci 
8Vggn^c\Egdc\h <gdjcYZY
DjiaZi
Figure 1. 5-15 Plug & receptacle.
Electrocution or fire could result if machine is not grounded cor- rectly or if electrical configuration does not comply with local and state codes. Ensure compliance by check- ing with a qualified electrician!
This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a
Extension Cords
We do not recommend the use of exten- sion cords, but if you find it absolutely necessary:
•Use at least a 14 gauge cord that does not exceed 50 feet in length!
•The extension cord must also contain a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor dam- age.
Model T10097 Wet Grinder