Grizzly t10493 Operations, Using the Angle Grinder, Never exceed RPM rating for wheels

Page 12

SECTION 4: OPERATIONS

This tool presents serious injury hazards to untrained users. Read through this entire manual to become familiar with the controls and operations before using the tool!

EYE INJURY HAZARD!

Wear safety goggles with full eye protection from all sides when using this grinder.

LUNG/EAR

INJURY HAZARD!

Wear protective equipment when using this tool.

ACCIDENTAL

START HAZARD!

Disconnect power before service or wheel changes.

Wheel SHATTER

HAZARD!

Never exceed RPM rating for wheels.

Using the Angle Grinder

Read and understand all safety instructions in this manual before starting.

Always test on a scrap piece of material similar to the workpiece. Trial and error is often the best way to determine the ideal setup.

To use the angle grinder:

1.If the workpiece is not completely stable on its own, make sure it is securely held in a vise or a similar device that will ensure it does not move during operation.

2.Make sure the grinding wheel is proper- ly secured on the spindle by tightening the outer flange.

Never use this tool without the guard installed. DO NOT modify the guard in any way. Using this tool with a removed or modified guard greatly increases the risk of personal injury.

3.Attach the grinder to the correct power supply.

4.Hold the grinder securely in both hands, and turn it ON.

5.Ease the wheel against the workpiece with a light but steady pressure.

6.Turn the grinder OFF.

-10-

T10493, T10494 & T10495 (Mfg Since 10/11)

Image 12
Contents Models T10493, T10494, T10495 4, 5 & 6 Angle Grinders Page Safety Safety Instructions For Power ToolsBefore Operating This Equipment Mation about proper operation of the equipmentSafety Instructions for Power Tools Additional Safety Instructions For Angle Grinders Introduction Foreword Contact InfoSpecifications IdentificationT10493 T10494 T10495 Setup UnpackingInventoryDescription Qty Assembly Adjusting the Wheel GuardInstalling the Handle To adjust the guardPower Connection Connecting PowerDisconnecting Power Polarized Plug RequirementsThen review Troubleshooting on Test RunGrinding Wheel on Page 16 for detailed Test run consists of verifying the followingUsing the Angle Grinder OperationsNever exceed RPM rating for wheels To use the angle grinderAccessories H4978 T20446 H4979T20928-Nuisance Dust Mask G7870 G7872 G7871 G7866 T21767G7867T24311-5 x 1⁄4 7⁄8 Bore Grind Wheel T24310-6 x 1⁄4, 7⁄8 Bore Grind WheelMaintenance Regular MaintenanceThese procedures should be done before and after each use Service TroubleshootingSymptom Possible Cause Solution Changing Motor Brushes Tools Needed QtyTo inspect/change Carbon Brushes StepInstalling/Changing Grinding Wheels To install or change the wheelParts T10494 & T10495 Main BreakdownT10494 & T10495 Main Parts List T10494 & T10495 Labels BreakdownT10493 Main Breakdown 3135T10493 Main Parts List T10493 Labels BreakdownWarranty Order Hours a DAY
Related manuals
Manual 24 pages 10.72 Kb