Grizzly t10493 Assembly, Adjusting the Wheel Guard, Installing the Handle, To adjust the guard

Page 9

Assembly

Adjusting the Wheel Guard

The wheel guards can be adjusted for maximum safety during grinding operations.

To adjust the guard:

1.Remove the wheel and both flanges.

2.Loosen the three Phillips head screws in the guard plate.

3.Rotate wheel guard to the desired position and retighten the screws loos- ened in Step 2.

Note: The mounting hardware for Model T10493 and Models T10494 and T10495 are different. For Model T10493, ensure that the guard plate clip is seated in one of the five posi- tion holes on the wheel guard, as shown in Figure 4.

Guard Plate

Clip

Phillips Head

Screw

Position

Holes

Figure 4. Adjusting the T10493 wheel guard.

4.Re-install the wheel and flanges (refer to Installing/Changing Grinding Wheels on Page 16).

Always consider the position of the wheel guard when installing the handle. NEVER operate the grinder with the handle installed toward the open face of the guard. This could lead to injury.

Installing the Handle

These Angle Grinders include a handle and mounting holes for different handle configurations, as shown in Figures 5–6. The handle provides added stability while operating the grinder. Choose the configuration that provides the most safe and stable grinder control for each task, and thread the handle into the appropriate hole.

Figure 5. Three handle configurations for T10494/T10495.

Figure 6. Two handle configurations for the T10493.

T10493, T10494 & T10495 (Mfg Since 10/11)

-7-

Image 9
Contents Models T10493, T10494, T10495 4, 5 & 6 Angle Grinders Page Safety Instructions For Power Tools SafetyBefore Operating This Equipment Mation about proper operation of the equipmentSafety Instructions for Power Tools Additional Safety Instructions For Angle Grinders Foreword Contact Info IntroductionSpecifications IdentificationT10493 T10494 T10495 Setup UnpackingInventoryDescription Qty Adjusting the Wheel Guard AssemblyInstalling the Handle To adjust the guardConnecting Power Power ConnectionDisconnecting Power Polarized Plug RequirementsTest Run Then review Troubleshooting onGrinding Wheel on Page 16 for detailed Test run consists of verifying the followingOperations Using the Angle GrinderNever exceed RPM rating for wheels To use the angle grinderH4978 T20446 H4979 AccessoriesT20928-Nuisance Dust Mask G7870 G7872 G7871 G7866 T21767G7867T24310-6 x 1⁄4, 7⁄8 Bore Grind Wheel T24311-5 x 1⁄4 7⁄8 Bore Grind WheelMaintenance Regular MaintenanceThese procedures should be done before and after each use Service TroubleshootingSymptom Possible Cause Solution Tools Needed Qty Changing Motor BrushesTo inspect/change Carbon Brushes StepTo install or change the wheel Installing/Changing Grinding WheelsT10494 & T10495 Main Breakdown PartsT10494 & T10495 Labels Breakdown T10494 & T10495 Main Parts List3135 T10493 Main BreakdownT10493 Labels Breakdown T10493 Main Parts ListWarranty Order Hours a DAY
Related manuals
Manual 24 pages 10.72 Kb