MN903
No. 275P Replaces 275N
LB7008
Instruction Manual For Baldor Grinders
SAFETY NOTICE:
| WARNING statements describe conditions that may lead to personnel injury including potentially |
| fatal injuries if the machine is not properly used and warnings are not properly followed. |
| Caution statements describe conditions that may lead to equipment damage. |
| Electrical shock can cause serious or fatal injury. Only qualified personnel should install, |
| maintain or troubleshoot this equipment. |
WARNING: | Do not operate this grinder until you are sure that you are completely familiar with the safe |
| operation of the grinder, all accessories and safety equipment. Improper use can lead to |
| severe injury. This manual defines proper use of this equipment. Before using this |
| equipment for any other use, please consult Baldor. Contact Baldor if you do not |
| understand any procedure or operation concerning this grinder or this manual. |
WARNING: | Prevent electrical shock hazard and accidental machine operation. Always disconnect |
| grinder from the power source before servicing, changing accessories (such as wheels, |
| tool rest, spark arrestor, etc.) or before performing maintenance. |
WARNING: | Avoid accidental starting. Make sure switch is in “OFF” position before connecting to |
| power source. |
WARNING: | Be sure the system is properly grounded before applying power. Do not apply power |
| before you ensure that grounds are connected. Electrical shock can cause serious or fatal |
| injury. Follow the National Electrical Code (NEC) and local codes for the safe installation |
| of this equipment. |
WARNING: | Always use safety glasses with side shields (or full face shield) when operating grinder. |
| Do not use ordinary eyeglasses. Also use face or dust mask if cutting operation is dusty. |
WARNING: | Unsuitable accessories or attachments added to this machine can create hazards. Baldor |
| accessories are specifically designed to be used with this grinder. Use accessories or |
| attachments only in the proper intended manner. Accessories or attachments obtained |
| from another source may cause hazards. Consult the manufacturer before use. |
WARNING: | Keep guards in place and in working order. Guards are design to prevent injury. Never |
| operate this equipment if a guard is damaged, missing or improperly installed. |
WARNING: | Remove adjusting keys and wrenches from this product after use. Check to see that keys |
| and adjusting wrenches are removed from grinder before turning it on. Projectiles can |
| cause severe injury to yourself or others. |
WARNING: | Keep work area clean and well lighted. Clutter and poor lighting invites accidents. |
WARNING: | Don’t use in dangerous environment. Don’t use grinders in damp or wet locations, or |
| expose them to rain. Electrical shock can cause serious or fatal injury. Follow the |
| National Electrical Code (NEC) and local codes for the safe installation of this equipment. |
WARNING: | Do not wear loose clothing, neckties, rings, bracelets, or other jewelry to get caught in |
| moving parts. Nonslip footwear is recommended. Wear protective hair covering to contain |
| long hair. |
WARNING: | Don’t over reach. Keep proper footing and balance at all times. A rotating wheel or belt |
| can catch an article of clothing and cause personnel injury. |
WARNING: | Secure work. Use clamps to secure the work piece when practical. It’s safer than using |
| your hand and it keeps hands away from wheel. |
WARNING: | When starting a grinder for the first time, or after installing a replacement grinding wheel, |
| it is most important that the operator stand aside for at least one minute of rotation at full |
| speed. This is the correct practice since grinding wheels can disintegrate if they have |
| received damage during shipping or handling. |
WARNING: | Always have the grinder switch in the “OFF” position when changing the position of the |
| pivot arm. Do not attempt to change the pivot arm position while the belt is moving as this |
| will create a hazardous situation for the operator. |
MN903 | 1 |