Baldor MN903 instruction manual Ginder Wheel, Installation

Page 3

SAFETY NOTICE Continued

Use wheels rated at or over rated grinder RPM shown in the following table.

D

W

 

 

Wheel Size

 

No Load RPM

 

 

 

 

 

•D" Diameter

•W" Width

•H" Arbor Diameter

 

(on Nameplate)

 

(inches)

(inches)

(inches)

 

 

 

 

 

 

 

 

6

3/

1/

1800

 

 

4

2

 

 

6

3/

1/

3600

 

 

4

2

 

 

7

1

5/

1800

 

 

 

8

 

H

7

1

5/8

3600

 

8

1

3/

1800

 

 

 

 

4

 

 

8

1

3/

3600

 

 

 

4

 

 

10

1

7/

1800

 

 

 

8

 

 

12

2

1-1/

1800

 

 

 

4

 

 

14

3

1-1/

1800

 

 

 

4

 

Grinding

 

 

 

 

Face

 

 

 

 

Ginder Wheel

 

Spark Arrestor

Eyeshield

Spark Arrestor

 

 

 

 

 

 

Eyeshield

 

 

 

Grinding Face

 

Grinding Face

 

Tool Rest

 

Wheel Flange

 

 

 

 

 

Guard Cover

 

Exhaust Port

 

Exhaust Port

 

 

 

On-Off Switch

 

Tool Rest

 

 

 

 

 

Tool Rest Support

 

 

Installation

When you receive your unit, there are several things you should do immediately.

1.Observe the condition of the shipping container and report any damage immediately to the commercial carrier that delivered the product.

2.Verify that the part number you received is the same as the part number listed on your purchase order.

WARNING:

When starting a grinder for the first time, or after installing a replacement grinding wheel,

 

it is most important that the operator stand aside for at least one minute of rotation at full

 

speed. This is the correct practice since grinding wheels can disintegrate if they have

 

received damage during shipping or handling.

3.Mount grinder on solid bench. The grinder must be securely bolted to a rigid mounting surface. If a pedestal is used, first bolt pedestal securely to floor and then bolt grinder to pedestal.

4.Check grinder nameplate to make certain the rating is correct for the power source, voltage and frequency. See electrical and grounding instructions for electrical service connection.

5.Adjust spark arrestor for approximately 1/16clearance between it and grinding wheel. Maintain 1/8or less clearance between spark arrestor and wheel as wheel wears.

6.Adjust angle of tool rest on support to desired position and tighten nut securely. Adjust

tool rest support on guard to attain approximately 1/16clearance between tool rest and grinding wheel and tighten nut securely. Maintain 1/8or less clearance between tool rest and wheel.

7.Adjust eyeshield to position aligning center of eyeshield in line of sight to tool rest.

MN903

3

Image 3
Contents Safety Notice Reproductive harm Safety NoticeEquipment or work area when not in use Gauge number, the heavier the cordGinder Wheel InstallationElectrical Instructions Operation Grounding InstructionsMinimum Gauge Wire Size MN903 Limited Warranty