Alpha Tool.Com.HK Limited 225, hsg-125 instruction manual Assembling Spindle Attachments

Page 15

ASSEMBLING SPINDLE ATTACHMENTS

CAUTION!

Do not leave threaded accessories on the spindle of the tool for extended periods of time, as this may result in making it difﬁcult to remove these accessories.

Note: The Alpha® High-Speed Angle Grinder has a 5/8”-11 spindle thread . It comes with two Inside Flange and Locking Flange sets: 20mm Arbor for 4” discs and 7/8” Arbor for 4-1/2” to 5” discs.

To attach an approved spindle attachment to the tool, follow the steps below:

CAUTION!

Always disconnect the plug from the electrical outlet before carrying out any work on the machine.

1.Mount the inside ﬂange. (use the 20mm Inside Flange and Locking Flange Set for 4” discs or the 7/8” Inside Flange and Locking Flange Set for 4-1/2”-5” discs).

Figure-9

2.Add the working tool and then the locking ﬂange as shown in Figure 10 and 11.

Cutting Wheel in photo is not included.

Figure-10

Figure-11

15

Image 15

Contents Alpha High-Speed Angle Grinder Table of Contents HIGH-SPEED Angle Grinder Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsWork Area General Safety RulesElectrical Safety Personal SafetyTool USE and Care ServiceUSE Proper Extension Cords Specific Safety RulesSafety Advice Additional Precautions for Using HIGH-SPEED Angle GrinderHOW to Handle the Grinder HOW to GrindSwitching on and OFF HIGH-SPEED Angle Grinder OperationMain Connection Before USE Switching offLaws and Regulations of Noise Levels About Double InsulationProtective Cover Installation Using the ToolAssembling Spindle Attachments Disassembling Spindle Attachments Rear Cover Removal Checking and Replacing the Carbon BrushesCarbon Brush Holder Removal Carbon Brush Removal Installing the Carbon Brushes Cleaning the CommutatorAlpha HIGH-SPEED Angle Grinder Schematic HSG-125 Alpha HIGH-SPEED Angle Grinder Parts List HSG-125 Only available with the HSG-125 Services and Warranty Information Need More Information WarrantyLoaner Program Company Headquarters Alpha Tool Repair ServiceElectric Hand Tool EC Declaration of ConformityProduct Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax