Alpha Tool.Com.HK Limited 225 Checking and Replacing the Carbon Brushes, Rear Cover Removal

Page 17

CHECKING AND REPLACING THE CARBON BRUSHES

In order to keep the tool running correctly, you need to check the carbon brushes after every one hundred hours of use. Carbon brushes wear out over time based on the grinder’s usage. If a carbon brush is worn out, it may cause the motor to malfunction or fail to run. The carbon brushes should be replaced before the twisted wire reaches the bottom of the slot.

DANGER!

Be sure to unplug the power cord from the outlet before servicing the unit, to prevent electrical shock or starting the tool accidentally.

REAR COVER REMOVAL

1.Remove the rear case screws.

Figure-15

2.Hold grinder with one hand and pull the rear case straight back with the other hand.

NOTE: Do not twist case in a side-to-side motion when pulling back.

Figure-16

2Pull back the rear case until the carbon brush assembly is exposed.

Figure-17

17

Image 17

Contents Alpha High-Speed Angle Grinder Table of Contents HIGH-SPEED Angle Grinder Overview SpecificationsComponents AccessoriesIntroduction About the SymbolsElectrical Safety General Safety RulesPersonal Safety Work AreaTool USE and Care ServiceUSE Proper Extension Cords Specific Safety RulesSafety Advice Additional Precautions for Using HIGH-SPEED Angle GrinderHOW to Handle the Grinder HOW to GrindMain Connection Switching on and OFFHIGH-SPEED Angle Grinder Operation Before USE Switching offLaws and Regulations of Noise Levels About Double InsulationProtective Cover Installation Using the ToolAssembling Spindle Attachments Disassembling Spindle Attachments Rear Cover Removal Checking and Replacing the Carbon BrushesCarbon Brush Holder Removal Carbon Brush Removal Installing the Carbon Brushes Cleaning the CommutatorAlpha HIGH-SPEED Angle Grinder Schematic HSG-125 Alpha HIGH-SPEED Angle Grinder Parts List HSG-125 Only available with the HSG-125 Loaner Program Services and Warranty InformationNeed More Information Warranty Company Headquarters Alpha Tool Repair ServiceElectric Hand Tool EC Declaration of ConformityProduct Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax