Alpha Tool.Com.HK Limited hsg-125, 225 instruction manual Carbon Brush Holder Removal

Page 18

Motor

Housing

Power Wire

Carbon Brush

Carbon Brush Assembly Parts

Coil

Spring

Carbon Brush Holder

Figure-18

CARBON BRUSH HOLDER REMOVAL

1.Disconnect the power wire from carbon brush holder.

Note: Each grinder has 2 carbon brushes located on opposite sides of each other.

Figure-19

2.Remove the carbon brush holder from the motor housing by pulling the holder out with a pair of needle nose pliers.

3.With the carbon brush holder removed, you can check and clean the armature commu- tator. The commutator is the contact points

that the carbon brushes ride on when the

motor is running. (See page 20 for cleaningFigure-20the commutator)

18

Image 18

Contents Alpha High-Speed Angle Grinder Table of Contents Specifications HIGH-SPEED Angle Grinder OverviewAccessories ComponentsAbout the Symbols IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaService Tool USE and CareSpecific Safety Rules USE Proper Extension CordsAdditional Precautions for Using HIGH-SPEED Angle Grinder Safety AdviceHOW to Grind HOW to Handle the GrinderSwitching on and OFF HIGH-SPEED Angle Grinder OperationMain Connection Switching off Before USEAbout Double Insulation Laws and Regulations of Noise LevelsUsing the Tool Protective Cover Installation Assembling Spindle Attachments Disassembling Spindle Attachments Checking and Replacing the Carbon Brushes Rear Cover RemovalCarbon Brush Holder Removal Carbon Brush Removal Cleaning the Commutator Installing the Carbon BrushesAlpha HIGH-SPEED Angle Grinder Schematic HSG-125 Alpha HIGH-SPEED Angle Grinder Parts List HSG-125 Only available with the HSG-125 Services and Warranty Information Need More Information WarrantyLoaner Program Alpha Tool Repair Service Company HeadquartersEC Declaration of Conformity Electric Hand ToolProduct Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax