Delta SH100 instruction manual Fence Assembly and Dust Chute, Machine. Note is shown from the rear

FENCE ASSEMBLY AND DUST CHUTE

Two fence halves are supplied as standard equipment with the Router/Shaper. To assemble and install the fence assembly, proceed as follows:

1. NOTE: The fence body with the see-thru cutter

guard (R) Fig. 7, assembled to it, is to be assembled to

the right hand side of the table, when facing the front of

the machine. (Note: Fig. 7 is shown from the rear of

the machine for clarity.) Place keyed bottom portion of

the left hand fence body (A) Fig. 7, in table slot (B). Insert

a 5/16-18x1-1/4" carriage head bolt (C) up through

bottom of table slot (B), place a 5/16" flat washer on bolt

and secure with fence knob (D).

2. Place back of wooden fence (E) Fig. 7, against front

of fence body (A), as shown. Line up hole in wooden

fence (E) with slot (F) in fence body (A) and fasten

wooden fence (E) to fence body by inserting a 3/8-16x1-

1/2" screw through hole in wooden fence and hole in

R

G E F

A

T

D B C

Fig. 7

H

N

M

fence body thread a 3/8-16 hex nut (G) onto the 3/8-

16x1-1/2" screw.

3. Assemble the right hand fence assembly (T) Fig. 7,

to the table in the same manner.

K

J

4. If you will be connecting your Router/Shaper to a

dust collection system, assemble the dust chute (H) Fig.

8, to the rear of the table by fastening bottom lip (M) of

dust chute to sheet metal plate (N) using two M4x8mm

cheese head screws (J). IMPORTANT: Make certain the

slot (K) in dust chute fits snugly around table lip (L). Also

make certain lip (M) of dust chute, is underneath sheet

metal plate (N). NOTE: If a dust collection system is not

going to be used, do not attach the dust chute.

5. Fig. 9, illustrates the dust chute (H) assembled to the

table.

6. Place dust hood (P) Figs. 9 and 10, over dust chute

(H) and fasten dust hood to back of fence body (A) using

two M5x10mm sheet metal screws (S), as shown in Fig.

10. NOTE: Dust hood (P) should always be used. Dust

chute (H) is used only with a dust collection system.

Fig. 8

P

A

H

Fig. 9

A

S

P

H

Fig. 10

8