Delta SH100 instruction manual Assembling Table Insert, Starting and Stopping ROUTER/SHAPER

ASSEMBLING

TABLE INSERT

The table insert (A) is assembled in the table, as shown in Fig. 11.

FASTENING

ROUTER/SHAPER

TO SUPPORTING

SURFACE

A

Fig. 11

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE ROUTER/SHAPER TO TIP OVER, SLIDE OR

WALK ON THE SUPPORTING SURFACE, THE

ROUTER/SHAPER SHOULD BE SECURED TO THE

SUPPORTING SURFACE. REMOVE THE FOUR

RUBBER FEET ATTACHED TO THE ROUTER/SHAPER,

AND FASTENING THE MACHINE TO THE SUPPORTING

SURFACE WITH FASTENERS (not supplied).

IF YOU PURCHASED THE ACCESSORY STAND, THE

FOUR PLASTIC FEET, SUPPLIED WITH THE STAND,

FEATURE HOLES WHICH ALLOW THE STAND TO BE

SECURED TO A SUPPORTING SURFACE WITH

FASTENERS (not supplied).

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING ROUTER/SHAPER

The on/off switch (A) Fig. 14, is located on the front of the Router/Shaper cabinet. To turn the machine “ON,” move the switch (A), up to the “ON” position. To turn the machine “OFF,” move the switch (A), down to the “OFF” position.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use. This can be done by grasping the switch toggle (B) Fig. 15, and pulling it out of the switch as shown. With the switch toggle (B) removed, the switch will not operate. However, should the switch toggle be removed while the machine is running, it can be turned “OFF” once, but cannot be restarted without inserting the switch toggle (B).

A

Fig. 14

B

Fig. 15

9