To Mount The Router Table On a Workbench

To Mount The Router Table On A Workbench:

1.CAUTION! Make sure the Router Table is securely attached to a dry, flat, level, sturdy workbench surface capable of supporting the weight of the unit, accessories, and workpieces.

2.At the bottom of each of the four Legs (1B) of the Router Table are two 1/4” diameter mounting holes. (See Assy. Diagram B.)

3.With assistance, place the Router Table in the desired location on the workbench. Then use the mounting holes (eight total) in the Legs (1B) as a template to mark where eight 1/4” diameter holes are to be drilled through the workbench.

4.Temporarily remove the Router Table from the workbench. Then, using a 1/4” drill bit (not included), drill the pre-marked holes through the workbench. Always check for hidden obstructions in the drilling path.

5.Place the Router Table back on the workbench and align the mounting holes in its Legs (1B) with the pre-drilled holes in the workbench.

6.Secure the Router Table to the workbench, using eight 1/4” diameter Bolts of appropriate length, eight Lock Washers, and eight Nuts (none included).

To Install The Miter Gauge:

Figure B

MITER GAUGE

(12B)

GUIDING GROOVE

(4B)

Make sure the Guiding Groove (4B) on the Worktable (5B) top is clean and free of all debris. Then, insert the Miter Bar of the Miter Gauge (12B) in the groove. Slide the Miter Gauge assembly forward and backward in the

groove to ensure proper installation. (See Figure B.)

SKU 95380

For technical questions, please call 1-800-444-3353

PAGE 10