3.The tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration.
(See 3-Prong Plug and Outlet.)
THE
ROUTER TABLE POWER CORD USES A
| Outlets for |
Double Insulated Tools: Tools with Two Prong Plugs
1.Tools marked “Double Insulated” do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code.
(See Outlets for 2-Prong Plug.)
2.Double insulated tools may be used in either of the 120 volt outlets shown in the preceding illustration. (See Outlets for
Symbology
|
|
| Double Insulated | V~ | Volts Alternating Current |
|
|
| |||
|
|
|
|
|
|
|
|
| Canadian Standards Association | A | Amperes |
|
|
|
| ||
|
|
|
|
|
|
|
|
| Underwriters Laboratories, Inc. | n0 xxxx/min. | No Load Revolutions |
|
|
| per Minute (RPM) |
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on pages 16 and 17 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
SKU 95380 | For technical questions, please call | PAGE 8 |