Attaching the Motor to the Router Base

908935 - 04-04-03.qxd 4/4/03 10:02 AM Page 10

ATTACHING THE MOTOR TO THE ROUTER BASE

REMOVE THE BATTERY.

1.Open the clamp (A) Fig. 3 and set the power unit in the base unit.

2.Align the lower pin of the power unit (B) Fig. 3 with the groove in the base.

3.Rotate the power unit CLOCK-WISE into the base until the upper guide pins are set in the groove of the base.

4.Close the clamp.

ADJUSTING DEPTH OF CUT

REMOVE THE BATTERY .

1.Open the clamp (A) Fig. 4.

2.Hold the base (E) and turn the power unit (F) Fig. 4 COUNTER-CLOCK- WISE until the tip of the bit is above the bottom of the base.

3.Set the tool on a flat surface.

4.Turn the power unit (F) Fig. 4 CLOCKWISE until bit touches the work.

5.Close the clamp (A) Fig. 4.

6.	Rotate the depth adjusting ring				F
(B) Fig. 4 until the zero-line (C) is		B
opposite the index line (D) on the
housing.			C
7.	Open the clamp (A) Fig. 4.		C		E
7.	Open the clamp (A) Fig. 4.
8.	Tip the router so that the bit is
8.	Tip the router so that the bit is
clear of the wood surface. Turn the
clear of the wood surface. Turn the
power unit (F) Fig. 4 CLOCKWISE
until the index line (D) on the motor
housing reaches the desired depth		A
indicated on the ring.

9. Close the clamp (A) Fig. 4.				Fig. 4

NOTE: Setting the index line to 1/4" on the ring means the cutting edge of the bit is exposed 1/4" below the base.

ADJUSTING SUB-BASE ALIGNMENT

Applications using a templet guide require the bit to be centered in the guide. This, in turn, requires the center hole in the sub-base to be in line with the collet of the motor unit. Your model has an adjustable sub-base which has been aligned at the factory. If the sub-base has been removed and/or readjustment is required, use the following procedure:

Be sure that the power switch is in “OFF” position and the battery is removed to avoid accidental starting of motor which could result in personal injury.