Jet Tools JDS-12B Canister Filter optional accessory, Cleaning the Filter, Optional Accessories

Canister Filter (optional accessory)

1.Remove the inlet port that came with the sander.

2.Mount the plastic elbow (A, Fig. 9) to the sander using the same hardware (B, Fig. 9) from the inlet port.

3.Connect the filter (C, Fig. 9) to the elbow and turn counter-clockwise so that it locks in place.

WARNING

Static electricity will build up in the filter

during operation. The filter ground must be attached to the machine ground, and to the filter. Failure to comply may result in fire/loss of property, or personal injury!

4.Remove the screw (D, Fig. 9) from the sander base. Attach the end of the grounding wire to the screw and thread back in to the base.

5.Attach the grounding clip (E, Fig. 9) to the metal part of the filter. This will prevent static electricity from building up in the filter.

Cleaning the Filter

CAUTION

Wearing a particle mask/respirator for

protection against fine dust particles during

cleaning is highly recommended.

Clean the canister filter frequently to keep the sander’s performance at its optimum. To clean:

1.Disconnect the machine from the power source.

2.Take off the grounding clip and remove the filter (C, Fig. 9) by turning clockwise.

3.Empty the contents into an appropriate container.

4.The filter can be cleaned with a low pressure air hose. Blow from the outside of the filter to clean the dust particles. For best results check and empty the filter frequently.

5.Install the filter and reattach the grounding clip.

Optional Accessories

708438: Open Stand

708434: Canister Filter

57620025: JET Stik Abrasive Belt and Disc Cleaner.

Dust Collectors and Accessories see a JET Distributor.

JDS-12B Sanding Disc PSA Aluminum Oxide “J” Weight Cloth Back.

12”	36 Grit	50 Grit	60 Grit
Stock	57698525	57698650	57698750
Number
Master	25	50	50
Carton
12”	80 Grit	100 Grit	120 Grit
Stock	57698850	57698950	57699050
Number
Master	50	50	50
Carton

12