Table Adjustment
The table stops have been
1.Loosen lock knobs (B, Fig. 4) and move the table to the 90 degree position. Tighten knobs and place a square (A, Fig. 4) against the table and disc. The square should rest flat against the table and disc.
2.If adjustment is needed move the table so that it rests 90 degrees from the table, and loosen the hex nut (D, Fig. 5) and tighten the set screw (C, Fig. 5) until it contacts the table surface. Tighten hex nuts. This will properly adjust the
3.Loosen the lock knobs (F, Fig. 5) and tilt the table up just enough to pivot the stop (E, Fig. 5) out of the way.
4.Tilt the table down until it hits the 45 degree stop (G, Fig. 5). Tighten lock knobs, and check the table with a combination square.
5.If adjustment is needed, loosen the hex nut (H, Fig. 5) and adjust the socket head cap screw (G, Fig. 5) until it contacts the table. Tighten hex nuts.
6.Always maintain a gap of approximately 1/16” between the table edge, and disc. If adjustment is necessary loosen hex cap bolts (I, Fig. 5) and move the table into position. Tighten hex cap bolts.
7.The table tilts between 15° up - 45° down by loosening the lock knobs and tilting the table to the desired angle. Tighten the knobs.
8.If you want to tilt the table up you need to pivot the stop (E, Fig. 5) out of the way.
Sanding Disc Replacement
1.Disconnect machine from the power source.
2.Remove the knobs (J, Fig. 6), washers (K, Fig. 6), and trunnion holders (L, Fig. 6) followed by the table assembly (M, Fig. 6).
3.Remove old sanding disc by striping from wheel. Use a cleaner and putty knife to remove the residue. Make sure the disc plate is clean and dry.
4.Press the new disc firmly into place.
10