Global Machinery Company SA120 instruction manual Maintenance, General Inspection

Page 10

Maintenance

WARNING. Always ensure that the tool is switched

off and the plug is removed from the power point before making any adjustments or maintenance procedures.

Keep the tool’s air vents unclogged and clean at all times.

Regularly check to see if any dust or foreign matter has entered the grills near the motor and around the on/off switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes whilst cleaning.

If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.

Never use caustic agents to clean plastic parts.

CAUTION. Water must never come into contact with the tool. Lubricate all moving parts at regular intervals.

General Inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

Power cord maintenance

If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.

10

Image 10
Contents Detail Sander Contents Dear Customer Description of symbolsSpecifications IntroductionSafety instructions Work areaAdditional safety rules for sanders ServiceContents of carton Know your product Adjusting the speed Switching on and offChanging and rotating the sanding base Attaching a sanding sheet Selecting the right grade of sandpaperSanding Dust extractionMaintenance General InspectionPage Save this Manual for future reference