Grizzly H8192 owner manual Assembly, Motor arbor centered

Page 15

Assembly

To avoid risk of serious injury, DO NOT connect the sander to power until told to do so in the Test Run subsection.

To assemble your combo sander:

1.Using 13mm wrenches, loosen the four motor mount hex bolts (Figure 6) so you can adjust the motor position in the next steps.

Motor Mounting

Hex Bolts (2 of 4)

Figure 6. Motor mounting hex bolts (2 of 4,

viewed from top).

2.With assistance, position the belt housing assembly on the left side of the base, taking care not to pinch the power cords between the assembly and the base.

3.Place the V-belt around both pulleys, and secure the belt housing assembly with the two M10-1.5 x 20 cap screws, lock washers, and flat washers (see Figures 7 & 8)—do not fully tighten the fasteners for now.

Model H8192 1" Belt/8" Disc Combo Sander

Assembly

Figure 7. Cap screws securing the belt housing assembly (viewed from underneath the base).

Belt Housing

Assembly

Base

Figure 8. Belt housing assembly installed.

4.Center the motor arbor in the cutout of the cast iron disc guard (see Figure 9), then re-tighten the motor mount hex bolts.

Arbor

Cutout

Figure 9. Motor arbor centered.

-13-

Image 15

Contents Model H8192 BELT/8 Disc Combination Sander Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Model H8192 identification IdentificationSafety Instructions for Machinery Model H8192 1 Belt/8 Disc Combo Sander Additional Safety Instructions for Belt and Disc Sanders 110V Operation Circuit RequirementsUnpacking SetupSetup Safety Items Needed for SetupInventory Inventory Figures QtyHardware not shown Qty Hardware Recognition Chart Clean Up Site ConsiderationsG7895-Grizzly Citrus Degreaser Motor arbor centered AssemblyDeflection Sanding disc table installed Sanding disc table angle scale Pointer installed To test run the sander Test RunTo connect a dust collection hose Mounting SanderOperations Operation Safety Disc SandingExample of 90 disc sanding Belt SandingAccessories Lubrication MaintenanceCleaning ScheduleChanging Sanding Belt Sandpaper Disc To change the sanding beltTo change the sanding disc Troubleshooting ServiceTo square the sanding disc table To adjust the V-belt tensionSquaring Disc Table Tensioning Replacing V-BeltSwitch wiring Electrical Components & Wiring DiagramSanding Belt & Motor Breakdown Sanding Disc Breakdown Description Parts ListLabel Placement Page Page Warranty and Returns