Grizzly H8192 owner manual Test Run, To test run the sander

Page 19

Test Run

Once the assembly is complete, test run your sander to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the switch disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 24.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the sander:

1.Make sure you have read the safety instructions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Connect the machine to the power source.

4.Verify that the machine is operating correctly by turning the machine ON.

When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

Model H8192 1" Belt/8" Disc Combo Sander

5.Turn the machine OFF.

6.Remove the switch disabling key, as shown in Figure 21.

Figure 21. Removing disabling key from the

toggle switch.

7.Flip the toggle switch to the ON position.

—If the machine does not start, the switch disabling feature is working as designed.

—If the machine starts, immediately stop the machine. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

8.When the Test Run has been successfully completed, check the tracking of the sanding belt and make adjustments if necessary (refer to Sanding Belt Tracking on Page 22).

-17-

Image 19
Contents Model H8192 BELT/8 Disc Combination Sander Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Model H8192 identification IdentificationSafety Instructions for Machinery Model H8192 1 Belt/8 Disc Combo Sander Additional Safety Instructions for Belt and Disc Sanders 110V Operation Circuit RequirementsUnpacking SetupSetup Safety Items Needed for SetupInventory Figures Qty InventoryHardware not shown Qty Hardware Recognition Chart Site Considerations Clean UpG7895-Grizzly Citrus Degreaser Motor arbor centered AssemblyDeflection Sanding disc table installed Sanding disc table angle scale Pointer installed To test run the sander Test RunTo connect a dust collection hose Mounting SanderOperations Operation Safety Disc SandingExample of 90 disc sanding Belt SandingAccessories Lubrication MaintenanceCleaning ScheduleTo change the sanding belt Changing Sanding Belt Sandpaper DiscTo change the sanding disc Troubleshooting ServiceTo square the sanding disc table To adjust the V-belt tensionSquaring Disc Table Tensioning Replacing V-BeltSwitch wiring Electrical Components & Wiring DiagramSanding Belt & Motor Breakdown Sanding Disc Breakdown Description Parts ListLabel Placement Page Page Warranty and Returns