Grizzly H8192 owner manual Changing Sanding Belt Sandpaper Disc, To change the sanding belt

Page 25

Changing the

 

Changing the

Sanding Belt

 

Sandpaper Disc

 

 

 

 

 

 

Some sanding belts are designed to sand in only one direction and will have a direction indicated on the back of the belt. The Model H8192 is designed so that the sanding belt travels downward to the sanding table.

To change the sanding belt:

1.DISCONNECT THE SANDER FROM POWER!

2.Unscrew the two knobs from the sanding belt cover and remove the cover from the sander (see Figure 32).

Sanding

Belt

Direction

Figure 32. Sanding belt cover removed.

3.Press down firmly on the tracking adjustment knob to remove the tension from the sanding belt.

4.Roll the old sanding belt off the three pulleys, and roll the new belt back on.

5.Make sure the sanding belt is positioned in the center of all three pulleys.

6.Replace and secure the sanding belt cover.

7.Check and the adjust the sanding belt traction, as instructed on Page 22.

Model H8192 1" Belt/8" Disc Combo Sander

The Model H8192 accepts 8" diameter cloth or paper-backed pressure sensitive adhesive (PSA) sandpaper discs (refer to Accessories on Page 21).

Refer to the Assembly subsection, beginning on Page 13, for detailed instructions for some of the following steps.

To change the sanding disc:

1.DISCONNECT THE SANDER FROM POWER!

2.Remove the sanding disc table, disc dust port, and dust cover.

3.Rotate the disc until you can see the set screw through the access hole (see Figure 33).

4.Using the 2.5mm hex wrench through the access hole in the V-belt safety cover, loosen the set screw and remove the sanding disc.

Set Screw

Access Hole

Figure 33. Location of access hole for the

sanding disc set screw.

5.Peel off the old sandpaper disc, clean the aluminum disc thoroughly, and apply the new sandpaper disc.

6.Reverse Steps 2–4above to reassemble your sander.

-23-

Image 25
Contents Model H8192 BELT/8 Disc Combination Sander Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Model H8192 identification IdentificationSafety Instructions for Machinery Model H8192 1 Belt/8 Disc Combo Sander Additional Safety Instructions for Belt and Disc Sanders 110V Operation Circuit RequirementsSetup Safety SetupItems Needed for Setup UnpackingInventory Figures Qty InventoryHardware not shown Qty Hardware Recognition Chart Site Considerations Clean UpG7895-Grizzly Citrus Degreaser Motor arbor centered AssemblyDeflection Sanding disc table installed Sanding disc table angle scale Pointer installed To test run the sander Test RunTo connect a dust collection hose Mounting SanderOperations Operation Safety Disc SandingExample of 90 disc sanding Belt SandingAccessories Cleaning MaintenanceSchedule LubricationTo change the sanding belt Changing Sanding Belt Sandpaper DiscTo change the sanding disc Troubleshooting ServiceSquaring Disc Table To adjust the V-belt tensionTensioning Replacing V-Belt To square the sanding disc tableSwitch wiring Electrical Components & Wiring DiagramSanding Belt & Motor Breakdown Sanding Disc Breakdown Description Parts ListLabel Placement Page Page Warranty and Returns