Grizzly P9933021 instruction sheet Spindle Upgrade KIT

	SPINDLE UPGRADE KIT
	FOR MODEL G9933
	INSTRUCTION SHEET
Why Did You Get This Kit?	Getting Started

The original spindles that came with your Model G9933 may have been over-hardened during man- ufacturing. Where this over-hardening occurred there is a danger of the spindle breaking and injur- ing the operator or bystander. Although we have not been notified that anyone has been injured as a result of these spindles, we shipped these supe- rior replacement spindles to you at no charge.

Due to the potential safety concerns involved with the original spindles, we strongly recommend that you STOP USING THIS MACHINE IMMEDIATELY and replace the original spindles with these supe- rior new spindles.

If you have any questions, feel free to contact our Technical Support at (570) 546-9663.

This procedure takes approximately one hour to complete and requires the following materials listed below.

Materials Needed			Qty
•	Safety Glasses	1 for each person
•	Brass Drift or Block of Wood		1
•	Hammer		1
•	Dead Blow Hammer		1
•	Retaining-Ring Pliers		1
•	Hex Wrench 5mm		1
•	Block of Wood (approximately 22"–23")		1
•	Blocks of Wood (equal dimensions)		2
•	Shop Rag(s)	As Needed
Upgrade Kit Contents
•	Spindles (P9933021)		3

Figure 1. New Spindle.

Copyright © May, 2008 By Grizzly Industrial, Inc.

Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.

#JM10721 printed in TAIWAN