MountingAssembly
The base of this machine has mounting holes that allow it to be fastened to a workbench or other mounting surface to prevent it from moving during operation and causing accidental injury or damage.
The strongest mounting option is a "Through Mount" (see example below) where holes are drilled all the way through the
Bolt |
Flat Washer |
Machine Base |
Workbench |
Flat Washer |
Lock Washer |
Hex Nut |
Figure 5. Example of a "Through Mount" setup.
Another option is a "Direct Mount" (see example below) where the machine is secured directly to the workbench with lag screws and washers.
Place the spindle hex nut, table inserts, sand- ing drums and sleeves, and spindle washers in the appropriate sized accessory slots beneath the table. A sanding drum does not need to be installed until after the test run.
|
| Sanding Drums |
Table Inserts |
| and Sleeves |
|
|
|
Figure 7. Assembled sander.
Lag Screw
Flat Washer
Machine Base
Workbench
Figure 6. Example of a "Direct Mount" setup.
Model G0739 (Mfg. Since 2/12) |