Dust Collection
DO NOT operate the Model G0739 without an adequate dust collection system. This sand- er creates substantial amounts of wood dust while operating. Failure to use a dust collec- tion system can result in short and
Recommended CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
To connect a dust collection hose:
1.Fit a 11⁄2" dust hose over the dust port shown in Figure 8 and secure in place with a hose clamp.
2.Tug the hose to ensure it does not come off. A tight fit is necessary for proper perfor- mance.
11⁄2" Dust Port
Figure 8. Dust port location.
Power Connection
After you have completed all previous setup instructions and circuit requirements, the machine is ready to be connected to the power supply.
To avoid unexpected startups or property dam- age, use the following steps whenever connecting or disconnecting the machine.
Connecting Power
1.Turn the machine power switch OFF.
2.Insert the power cord plug into a matching power supply receptacle. The machine is now connected to the power source.
Figure 9. Connect power.
Disconnecting Power
1.Turn the machine power switch OFF.
2.Grasp the molded plug and pull it completely out of the receptacle. Do not pull by the cord as this may damage the wires inside.