Mounting Sander
This step may require three people to complete— two to lift and hold the sander in place, and one person to install the hardware.
Components and Hardware Needed: | Qty |
Sleeve | 1 |
Hex Bolt | 1 |
Hex Nut | 1 |
Flat Washers 12mm | 2 |
Helpers | 2 |
Angle Adjustment Lever | 1 |
To mount the sander to the base: |
|
1.Set the base in the upright position.
2.Slide the sleeve through the holes so it spans the width of the base yoke.
3.With the aid of a couple helpers, lift the sand- er, spread the yoke on the sander slightly and set onto the base (see Figure 10).
4.Slide the 30mm bolt and washers through the sleeve and tighten the nut.
5.Thread the angle adjustment lever through the slot and tighten the sander in position.
Spark Trap, Rest & | |
Eye Shield |
|
Theses components MUST be mounted before | |
operation. |
|
Components and Hardware Needed: | Qty |
Spark Trap | 1 |
Eye Shield | 1 |
Rest | 1 |
Rest Lever | 1 |
Square Nut | 1 |
Cap Screw | 1 |
To mount the spark trap, rest, & eye shield: | |
1. Refer to Figures |
|
| |
Sleeve