Grizzly G0489 owner manual Dust Collection, Test Run

Page 17

Rest

Rest Lever

 

Square Nut

Figure 13. Rest installation.

Dust Collection

DO NOT operate the Model G0489 with a

dust collection system that has been previ-

ously used for wood dust collection or other

combustible material. Hot metal sparks and

fragments could cause material to ignite! DO

NOT attach to plastic fittings or dust collec-

tion system not rated specifically for metal

dust collection!

The Model G0489 comes with a 4" dust port

ready to attach to your metal dust collection sys-

tem. Your dust collection system is unique so we

cannot give you specific instructions to cover all

the possible set up options.

To connect a dust collection hose:

1.

Fit your dust hose over the dust port and

 

secure in place with a hose clamp.

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately.

If you cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Connect the machine to the power source.

2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

3.Make sure all tools and objects used during set up are cleared away from the machine.

4.Turn the machine ON.

5.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

G0489 Metalworking Sander

-15-

Image 17
Contents Model G0489 Metalworking Sander Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Machine Identification IdentificationSafety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Belt Sanders Circuit Requirements 220 3-PhaseExtension Cords Grounding Phase ConverterSet Up Safety SET UPItems Needed for Set Up UnpackingBox 1 Figures 4 Qty InventorySite Considerations Clean UpBolting to Concrete Floors Mounting to Shop FloorEye Shield Mounting SanderSpark Trap, Rest Test Run Dust CollectionRests Operation Safety Angle AdjustmentOperations Belt Tracking To adjust the belt trackingGrinding Tips Accessories MaintenanceSchedule Changing the BeltElectrical Components & Wiring Diagram G0489 Parts Breakdown Description G0489 Parts ListWarranty and Returns Page Page