SECTION 2: SET UP
Set Up Safety
This equipment pres- ents serious injury haz- ards to untrained users. Read through this entire manual to become famil- iar with the controls and operations before start- ing the equipment!
Items Needed for
Set Up
The following items are needed to complete the set up process, but are not included with your equipment:
Description | Qty | |
• | Phillips Screwdriver #2 | 1 |
• | Standard Screwdriver #2 | 1 |
• | Teflon Tape | 1 |
• | Wrench 10mm | 1 |
• | Wrench 17mm | 1 |
• | Wrench 22mm | 1 |
G0474/G0475 Sandblasters
Unpacking
The Model G0474/G0475 was carefully packed when it left our warehouse. If you discover the equipment is damaged after you have signed
for delivery, please immediately call Customer Service at (570)
Save the containers and all packing materials for possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
Compressor
Sandblasting operations are extremely demand- ing on some compressors and can cause a com- pressor overload or overheated condition. Refer to your compressor Owner's Manual and make sure that it can handle the load of sandblasting. If it can, you must follow these setup recommenda- tions:
We recommend using a compressor that is 5 HP and above with a minimum of a 12 CFM rating.
Keep your compressor completely isolated from your sandblasting environment, or keep the work area downwind from the compressor. Airborne abrasive dust will destroy rings, pistons, valves, and bearings.
Make sure to increase the maintenance interval of your compressor if using it in sandblasting opera- tions.