Grizzly G0724 MountingAssembly, Machine Base Workbench, Tools Needed Qty, To assemble the sander

Page 15

MountingAssembly

The base of this machine has mounting holes that allow it to be fastened to a workbench or other mounting surface to prevent it from moving during operation and causing accidental injury or damage.

The strongest mounting option is a "Through Mount" (see example below) where holes are drilled all the way through the workbench—and hex bolts, washers, and hex nuts are used to secure the machine in place.

Bolt

Flat Washer

Machine Base

Workbench

Flat Washer

Lock Washer

Hex Nut

Figure 5. Example of a "Through Mount" setup.

Another option is a "Direct Mount" (see example below) where the machine is secured directly to the workbench with lag screws and washers.

Lag Screw

Flat Washer

Machine Base

Workbench

Figure 6. Example of a "Direct Mount" setup.

Model G0724 (Mfg. Since 09/11)

Tools Needed

Qty

Hex Wrench 4mm

1

Phillips Screwdriver

1

To assemble the sander:

1.Remove the two cap screws 5mm and bushings from the table and the sander assembly, as shown Figure 7.

Cap Screws

Pointer

Figure 7. Location of cap screws and pointer.

2.Position the angle gauge of the table over the two cap screw and bushing holes located above the pointer.

3.Install the pilot cap screw on the right side of the table, attaching it to the sander.

4.Replace the two cap screws and bushings removed in Step 1.

5.Install the table tilt lever and washer between the two cap screws and bushings.

6.Set table to 90° (see Table Tilt Calibration on Page 24), and reinstall the pointer at 0°.

7.Rotate the disc by hand and make sure it turns freely.

-13-

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model G0724 Disc Sander Page Table of Contents Introduction Manual Accuracy Contact InfoMachine Description G0724 controls and components IdentificationMachine Data Sheet Safety Instructions for Machinery SafetyPage Additional Safety for Disc Sanders Circuit Requirements Power SupplyAvailability Full-Load Current Rating50 ft Grounding & Plug RequirementsExtension Cords Minimum Gauge SizeUnpacking SetupNeeded for Setup InventoryCleanup Before cleaning, gather the followingBasic steps for removing rust preventative Site Considerations To assemble the sander MountingAssemblyMachine Base Workbench Tools Needed QtyTo install the dust collection bag Dust Collection Power ConnectionConnecting Power Disconnecting PowerTo test run the machine Test RunOperation Overview OperationsReplacing Sandpaper Disc SandingTo replace the sanding disc Miter slot and work path Rotation To use the disc sanderAccessories Dust Collectors RespiratorsLubrication MaintenanceCleaning ScheduleService TroubleshootingMotor & Electrical Workpiece Finish To calibrate the table tilt Miter Gauge CalibrationTable Tilt Calibration To calibrate the miter gaugeWiring Safety Instructions Wiring110 VAC Wiring DiagramMain PartsDescription Main Parts ListLabels Model G0724 Mfg. Since 09/11 Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCWarranty & Returns Order Hours a DAY
Top Page Image Contents