Harbor Freight Tools 05154 operating instructions Figure H, To Adjust The Angle Of The Miter Guide

Page 13

WORK TABLE (13)

ANGLE PLATE (14)

LOCK

SCREW

(15)

FIGURE H

To Adjust The Angle Of The Miter Guide:

1.The angle of the Miter Guide (21) may be adjusted to the right 0 to 45 degrees and to the left 0 to 45 degrees. (See Figure I.)

2.To adjust the angle of the Miter Guide (21), slightly loosen the Miter Guide Knob (22). (See Figure I.)

3.Observe the gauge on the Miter Guide (21). Move the Miter Guide to the right or left until the desired angle is indicated on the gauge. Then, retighten the Miter Guide Knob (22) to lock the Miter Guide in place. (See Figure I.)

MITER GUIDE KNOB (22)

MITER GUIDE (21)

FIGURE I

SKU 05154

PAGE 13

Image 13

Contents For technical questions, please call Sander 4 Belt & 6 DiscGeneral Safety Rules Product SpecificationsSave this Manual UnpackingPersonal Safety Electrical SafetyTool USE and Care Grounding ServiceGrounded Tools Tools with Three Prong Plugs Figure a Double Insulated Tools Tools with TWO Prong Plugs Extension CordsFigure C See Figure CSpecific Safety Rules SymbologyDo not allow children to handle or play with this product Industrial applications must follow Osha requirements Page Assembly Diagram on Assembly and Operating InstructionsTo Install a Sanding Belt See Figures E and FTo Adjust The Angle Of The Work Table To Install a Sanding DiscSee Figure G Figure H To Adjust The Angle Of The Miter GuideTo Perform Horizontal Sanding With The Sanding Belt To Adjust For Vertical SandingSee Figure K, next See Figure KSee Figure L, next To Perform Vertical Sanding With The Sanding BeltSee Figure L See Figure M, next To Perform Horizontal Sanding With The Sanding DiscSee Figure M Figure M INSPECTION, MAINTENANCE, and CleaningPlease Read the Following Carefully Description Qty Parts ListAssembly Diagram & Wiring Schematic