Assembling the Sander
Tools Required for Assembly (not provided):
Ratchet wrench with extension 7/16”, 9/16” and 1/2” sockets 9/16”
Flat blade screwdriver
Installing Drum Head
1.Lift the drum head assembly out of the box, and temporarily rest it crosswise on top of the stand. (If your stand has casters, make sure they are locked.)
The drum head is heavy; use an assistant to help lift if needed.
2.Mount the knob to the height adjustment handle. See Figure 5. Tighten the hex nut against the handle base with a 9/16” wrench.
3.Rotate the height adjustment handle clockwise to raise the drum and free the wood support blocks.
4.Use a 9/16” socket wrench to remove the hex cap screws and flat washers which secure the plywood boards to the bottom of the sander base. Retain these screws and washers for step 6.
5.Position the drum head assembly on top of the stand so that the four threaded holes of the base align with the holes in the long rails of the stand (Figure 6).
[NOTE:The four holes at the center of the long rails are not used with the
6.Fasten base to stand (from beneath) with the four screws and flat washers that you removed from the plywood boards. See Figure 6. Tighten the screws securely.
Installing Conveyor
1.Raise the sanding drum to its highest elevation by rotating the height adjustment handle (Figure 5) in a clockwise direction.
2.Install the conveyor bed to the base so that the conveyor mounting holes align with the holes in the base. Install four 5/16” hex washer head screws (A, Figure 7).
3.Insert plug of motor cord (B, Figure 7) into the control box receptacle.
10
Figure 5
Figure 6
Figure 7