Jet Tools 16-32 Plus operating instructions Assembling the Stand, Casters Optional Accessory

Page 9

Assembling the Stand

(Refer to Figure 4. If further clarification is needed, consult the parts breakdown on page 28.)

Tools required for Stand assembly: Ratchet wrench with 1/2” socket

1.Assemble legs (H) to outside of Short Rails (L) using carriage bolts (N) and flanged lock nuts (O). Finger tighten only.

2.Assemble Long Rail (K) on inside of legs and on top of Short Rails (L). Finger tighten only. NOTE: Flange of Long Rail (K) overlaps flange of Short Rail (L). See Detail 1 below.

3.Turn stand upside down. Install shelf (J) into legs (H) using carriage bolts and lock nuts.

4.Fully tighten all flanged lock nuts in shelf and legs.

5.If you are using the provided leveling foot (M), place it in bottom hole of leg by placing a hex nut (P) and flat washer (R) above and below the leg flange. If you are mounting the optional casters, see “Casters” below.

6.Turn stand right-side up, and level it using the leveling feet. Tighten the leveling feet hex nuts against the leg flange.

Casters (Optional Accessory)

1.If you are installing the optional casters, press down on the tab to lock the caster, then remove the hex nut and washer with a 19mm wrench. Install the caster through the hole in the stand leg and secure it with the washer and hex nut. See Detail 2 below.

2.Press down with your foot on the large tab to lock a caster; press down on the small tab to unlock it.

Figure 4

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Drum Sander Warranty and Service Table of Contents Page Page Introduction Specifications Features and Terminology Unpacking Contents of BoxesAssembling the Stand Casters Optional AccessoryInstalling Drum Head Installing ConveyorAssembling the Sander Infeed/Outfeed Tables Optional AccessoryDust Collection Installing AbrasivesPage Grounding Instructions Switch Lock AdjustmentsExtension Cords Drum Height ControlConveyor Belt Replacement Dust Cover LatchConveyor Belt Tension/Tracking Sanding Drum Alignment Fine-Tuning Drum Alignment Drum Height Control AdjustmentTension Roller Alignment Tension Roller Pressure AdjustmentOperation Sanding Multiple Pieces At Once Multiple-Piece Sanding RunsUnderside of conveyor shown Tracker KitTroubleshooting MaintenanceAlign shaft flats of gear motor Abrasive Selection Guide AbrasivesReplacement Parts Optional AccessoriesIndex No. Part No Description Size Qty Parts List Stand AssemblyConveyor and Motor Assembly Parts List Conveyor and Motor Assembly Drum Head Assembly JWTS10-MRS Parts List Drum Head AssemblyParts List Infeed/Outfeed Tables Optional Accessory Electrical Connections Page Page WMH Tool Group
Top Page Image Contents