![](/images/new-backgrounds/1241059/24105917x1.webp)
Assembly
Tools required for assembly:
Hoist, forklift, or one or more assistants
Wrenches – 9/32”, 1/2” , 9/16”
Hex wrenches – 4mm, 1/8”
Install Stand Legs
The sander is heavy; use caution when lifting.
1.Raise the sander from the floor using a forklift, hoist or an assistant. (Place hoist straps through the carriage arm or below the table mounting brackets. If using a forklift, fork below the table mounting brackets. See Figure 1, page 7.)
2.Position the assembly fixtures below the columns so that the wider part of the plywood faces outward (Figure 3). Lower the sander columns into the assembly fixtures.
3.Mount the four legs to the columns, using
4.Lift the sander and remove the assembly fixtures.
5.With the sander raised, install the four leg glides, (or optional casters, not provided). See Figure 4. If using the casters, first lock the caster by pressing the large tab, in order to remove the hex nut and flat washer.
Table Support Screws
The set screws on the table supports (Figure 5) have been tightened at the factory to eliminate
Failure to follow the below procedure may result in misalignment of the drum and/or conveyor bed, or may damage the miter gears.
1.Loosen each hex nut with an
9
Figure 3
Figure 4
Figure 5