Dymo 31-250 Operating Controls and Adjustments, Starting and Stopping the Machine

Page 10

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING THE MACHINE

1.The drum motor on/off switch (A) Fig. 12 is located underneath the switch shield (B). To turn the drum “ON”, move switch (A) to the “ON” (up) position.

2.To turn the drum “OFF”, push down on switch shield

(B) Fig. 13. NOTE: This switch only controls the drum. See “TABLE FEED/SPEED SWITCH” for feed table switch instructions.

B

A

Fig. 12

LOCKING THE DRUM SWITCH IN THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (C) Fig. 14 with a 3/16" diameter shackle.

B

Fig. 13

D

C

Fig. 14

TABLE FEED/SPEED SWITCH

The “FEED/SPEED” switch, (A) Fig. 15 is located above the drum motor on/off switch shield (B). Rotate the knob

(A)Fig. 15 clockwise to turn the table motor on and continue to turn it in order to increase the table feed/speed rates and counter-clockwise to decrease the speed rates.

To turn the feed table "OFF", turn the knob in a counter- clockwise direction until it CLICKS "OFF".

A

B

Fig. 15

10

Image 10

Contents 18 x 36 Drum Sander Safety Guidelines Definitions Important Safety InstructionsStay ALERT, Watch What YOU are Doing Additional Safety Rules For Drum Sanders Hold the Work Firmly when sandingPower Connections Unpacking and Cleaning Foreword Carton Contents Drum Sander PartsAttaching Legs AssemblyAttaching the Handwheel Attaching and Leveling Feed Table Attaching Thickness ScaleTable FEED/SPEED Switch Operating Controls and AdjustmentsLocking the Drum Switch in the OFF Position Starting and Stopping the MachineRaising and Lowering Feed Table Checking and Adjusting Feed Belt Tracking and TensionDisconnect Machine from Power Source TrackingChanging Drum SPEEDS/REPLACING Drive Belt Checking and Adjusting Table Parallel to DrumSetting the Height Scale Table Height AT this TimeRemoving and Replacing Drum Sanding Belt To relieve tension on the belt. Replace or change the beltRemoving and Replacing Feed Belt Dust CollectionWhat is Recommended for Dust Collection Frequently Asked QuestionsWhen do I Change the Drum SPEED? What Factors Affect Sanding OPERATIONS?HOW do I Sand Multiple BOARDS? What Causes Burn MarksWhat are the Maximum and Minimum Sanding Stock SIZES? HOW do I Sand the Edges of BOARDS?HOW do I GET STARTED? HOW do I Sand Glued BOARDS?HOW do I Sand Boards Wider than 18? Tips for Increasing Sanding Belt LifeTension on Timing Belt Table Movement Troubleshooting GuideChecking the Table Support Plate Checking Lock NUT Adjustment Lock NUT AdjustmentDrum Motor Overload Protection MaintenanceBrush Inspection and Replacement Feed Belt Motor Overload ProtectionPage Page Accessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers