Delta (Model 31-300) Operation, Attaching Belt Table, Starting and Stopping the Machine

Page 12

ATTACHING BELT TABLE

B

D

A

C

Fig. 14

E

Fig. 15

DISCONNECT MACHINE FROM POWER SOURCE.

1.Insert the trunnion key (A) Fig. 14 into the slot on the side of the sanding arm (B).

2.Thread the stud (C) into the hole (D) on the side of the sanding arm.

3.Attach the washer, nut, lever, spring, and locknut (Inset - Fig 15)

4.Tighten the lever (E) Fig.15.

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

A

Fig. 16

A

Fig. 17

A

Fig. 18

STARTING AND STOPPING THE MACHINE

The on-off switch (A) Fig. 16 is located on the sander base. To turn the sander “ON”, move the switch to the up position. To turn the sander “OFF”, move the switch to the down position.

12

Image 12

Contents Sanding Center 6 Belt/12 Disc Sander Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsAdditional Specific Safety Rules Refer to them often and use them to instruct othersPower Connections Motor SpecificationsGrounding Instructions Volt Single Phase Operation Extension CordsFunctional Description Assembly Unpacking and CleaningAssembly Tools Required Assembling StandInstalling Drive Belt and Belt Guard Attaching Motor to StandAttaching Machine to Stand Attaching Sanding Disc Attaching Disc TableOperation Attaching Belt TableStarting and Stopping the Machine Locking Switch in the OFF Position Adjusting Tension Tracking of the BeltOverload Protection Adjusting Sanding Belt Degrees to Belt Tilting the Belt Sander TableChanging Position of Sanding ARM Adjusting Sanding Disc Degrees to Disc Tilting the Disc Sander TablePower TAKE-OFF Shaft Replacing Sanding BeltReplacing Sanding Disc Surfacing or Edge Sanding with Sanding Belt Sanding Inside CurvesSanding Outside Curves END Sanding with the Disc END Sanding Wide Workpieces with the BeltTroubleshooting Maintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers