Delta (Model 31-300) instruction manual Sanding Center 6 Belt/12 Disc Sander

Page 1

Sanding Center 6" Belt/12" Disc Sander

(Model 31-300)

INSTRUCTION MANUAL

PART NO. 913131 - 04-12-05

Copyright © 2005 Delta Machinery

To learn more about DELTA MACHINERY

visit our website at: www.deltamachinery.com.

For Parts, Service, Warranty or other Assistance,

please call 1-800-223-7278 (In Canada call 1-800-463-3582).

Image 1

Contents Sanding Center 6 Belt/12 Disc Sander Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesRefer to them often and use them to instruct others Additional Specific Safety RulesMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Volt Single Phase OperationFunctional Description Unpacking and Cleaning AssemblyAssembly Tools Required Assembling StandAttaching Motor to Stand Installing Drive Belt and Belt GuardAttaching Machine to Stand Attaching Disc Table Attaching Sanding DiscAttaching Belt Table OperationStarting and Stopping the Machine Adjusting Tension Tracking of the Belt Locking Switch in the OFF PositionOverload Protection Tilting the Belt Sander Table Adjusting Sanding Belt Degrees to BeltChanging Position of Sanding ARM Tilting the Disc Sander Table Adjusting Sanding Disc Degrees to DiscReplacing Sanding Belt Power TAKE-OFF ShaftReplacing Sanding Disc Sanding Inside Curves Surfacing or Edge Sanding with Sanding BeltSanding Outside Curves END Sanding Wide Workpieces with the Belt END Sanding with the DiscService Troubleshooting MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers