Delta (Model 31-300) Power TAKE-OFF Shaft, Replacing Sanding Belt, Replacing Sanding Disc

Page 17

D

A

Fig. 36

A

B

C

Fig. 37

4.To adjust, loosen the four screws, two of which are shown at (D) Fig. 36. Adjust the table until the miter gauge slot is parallel to the disc. Tighten the four screws (D).

NOTE: When making this adjustment, tighten the lock handle (A) Fig. 36.

IMPORTANT: Maintain a maximum distance of 1/16" between the sanding disc and the table.

POWER TAKE-OFF SHAFT

DISCONNECT MACHINE FROM POWER SOURCE

1.A power take-off shaft (A) Fig. 37 is provided on the lower end of the sanding belt arm to accommodate accessories.

2.For access to the power take-off shaft, remove the two screws (B) Fig. 37, and cover (C).

Unguarded rotating shafts (A) Fig 37 can create an entanglement hazard. ALWAYS COVER THE POWER TAKE-OFF SHAFT when not using accessories.

REPLACING SANDING BELT

To replace the sanding belt:

DISCONNECT MACHINE FROM POWER SOURCE

1.Loosen the two lock knobs (A) Fig. 38, and remove the top cover (B).

2.Loosen the two screws (C) Fig. 39 enough to allow the back panel (D) Fig. 38 to hinge open. NOTE: The screw (C) cannot be removed.

3.Release the belt tension by turning the hand lever (E) Fig. 38. Slide the belt (F) Fig. 40 off of both sanding drums.

4.Slide the new sanding belt over both sanding drums. Ensure that the belt runs in the direction of the arrow, printed on the inside of the belt.

5.Apply tension to the sanding belt and replace the top cover removed in STEP 2.

6.Tighten the two screws loosened in STEP 3.

7.Connect the power source to the sander and check for proper belt tracking.

B

E

A

D

Fig. 38

REPLACING SANDING DISC

C

Fig. 39

F

Fig. 40

DISCONNECT MACHINE FROM POWER SOURCE.

See “ATTACHING SANDING DISC” section in this manual.

17

Image 17
Contents Sanding Center 6 Belt/12 Disc Sander Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesRefer to them often and use them to instruct others Additional Specific Safety RulesGrounding Instructions Power ConnectionsMotor Specifications Extension Cords Volt Single Phase OperationFunctional Description Unpacking and Cleaning AssemblyAssembly Tools Required Assembling StandAttaching Machine to Stand Installing Drive Belt and Belt GuardAttaching Motor to Stand Attaching Disc Table Attaching Sanding DiscStarting and Stopping the Machine OperationAttaching Belt Table Overload Protection Locking Switch in the OFF PositionAdjusting Tension Tracking of the Belt Tilting the Belt Sander Table Adjusting Sanding Belt Degrees to BeltChanging Position of Sanding ARM Tilting the Disc Sander Table Adjusting Sanding Disc Degrees to DiscReplacing Sanding Disc Power TAKE-OFF ShaftReplacing Sanding Belt Sanding Outside Curves Surfacing or Edge Sanding with Sanding BeltSanding Inside Curves END Sanding Wide Workpieces with the Belt END Sanding with the DiscService Troubleshooting MaintenanceWarranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers