UNPACKING AND CLEANING
Your new Disc Sander is shipped complete in one container. Carefully unpack the sander and all loose items from the shipping container. Fig. 2, illustrates the sander and all loose items. Remove the protective coating from machined sur- faces of the machine. This coating can be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover all unpainted surfaces with a good quality paste wax.
1 - Sander
2 - Hose
3 - 4mm Hex Wrench
4 - 8mm - 10mm
1
2
4 | 3 |
|
Fig. 2
ASSEMBLY INSTRUCTIONS
The 12" Disc Sander is shipped completely assembled, except the dust hose. 
WARNING: FOR YOUR OWN SAFE-
TY, DO NOT CONNECT THE SANDER TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEM- BLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE OWNER’S MANUAL.
INSTALLING DUST HOSE
The 12" Disc Sander has an efficient, integral fan which provides excellent dust collection. We suggest that a dust collector of some kind be hooked up to the machine. If dust collection is not available, insert one end of the supplied dust hose (A) Fig. 3, into the dust port (B) of the sander as shown and drape dust hose (A) down into a garbage can. Dust port (B) measures
B A
Fig. 3
FASTENING SANDER TO SUPPORTING SURFACE
IMPORTANT: IF DURING OPERATION THERE IS ANY TENDENCY FOR THE SANDER TO TIP OVER, SLIDE OR WALK ON THE SUPPORTING SURFACE, THE SANDER MUST BE SECURED TO THE SUPPORTING SURFACE USING FASTENERS THROUGH THE FOUR HOLES (C) FIG. 4.
C
C
Fig. 4
4