Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch (11) off and unplug the Polisher from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To Attach The Polishing Bonnet, Foam Bonnet, And Sanding Disc:
FOAM
FIGURE ABONNET
(53)
SANDING | POLISHING |
DISC (54) | BONNET (52) |
1.The face of the Mounting Disc (51) and backs of the Polishing Bonnet (52), Foam Bonnet (53), and Sanding Disc
(54) have a
(See Figures A and B.)
2.To attach the Polishing Bonnet , Foam Bonnet, or Sanding Disc to the Mounting
Disc simply press the accessory firmly
onto the Mounting Disc.
(See Figures A and B.)
3.Make sure the accessory is placed evenly on the Mounting Disc and is secure before turning on the tool.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the Power Cord (5) along a safe route to reach the work area without creating a tripping hazard or exposing the Power Cord to possible damage. The Power Cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
5.Make sure to read and understand all instructions and safety precautions as outlined in the manufacturer’s manual for the object you will polish or sand.
6.If waxing and polishing, make sure the object being waxed and polished is free from burrs and any other foreign matter which could damage the Bonnets (52, 53).
SKU 66615 | For technical questions, please call | Page 11 |